Page 1 of 1
OpenClip
Posted: Tue Dec 31, 2019 3:46 am
by Mikeconcentric
I would like to have OpenClip between PowerCADD and FromZ working again. The last time I looking into this the people from FormZ were unable to get a response from you'll or maybe it was the other way around.
Thanks!
OpenClip
Posted: Tue Dec 31, 2019 1:58 pm
by Alfred Scott
Mike,
Not aware of any missed communication with FormZ folks. I talk to them regularly, and we are working on an idea right now. They are great people.
Problem with OpenClip not working is completely understood. PowerCADD is 32-bit and clipboard routines in the latest MacOS are 64-bit. Not compatible.
Workaround is to use OpenClip Bridge app at
www.openclip.net.
Alfred
OpenClip
Posted: Tue Dec 31, 2019 3:02 pm
by Alfred Scott
Oops. Make that OpenClip Viewer app.
Alfred
OpenClip
Posted: Tue Dec 31, 2019 3:11 pm
by Mikeconcentric
Thanks!