Erratic Keyboard behavior in Parallels

[rjmuller]

Hi:

I'm running PC in a Mojave Parallels VM. Two things are happening:
The shift key will not constrain to horizontal or vertical (or the other designated angles). I switched to custom angle settings and it worked once and then stopped constraining.

Wild Tools, Option-Control Click-Drag will not create a Zoom Window, only the secondary menu comes up.

Any ideas?

Robert

iMac Pro, Catalina, Parallels 15.1.4, Mojave 10.14.6, PowerCADD 9.1.8 (RB15), WT 10.1.3 v5

[Matt_A]

iMac Pro Mojave 10.14.6, PowerCADD 9.1.8 (RB15), WT 10.1.3 v5

[Alfred Scott]

Possible operator error!

If it’s Zoomer you are after, try the command key instead of the control key.

Alfred

[rjmuller]

Thanks Alfred,

Sadly, I looked it up in the WildTools 9 Manual that I still have and promptly started using the ctrl instead of command.

Any thoughts on why shift is not working to draw a horizontal line?

Robert

[eddiebello]

Thanks Alfred,

Sadly, I looked it up in the WildTools 9 Manual that I still have and promptly started using the ctrl instead of command.

Any thoughts on why shift is not working to draw a horizontal line?

Robert

Was this ever resolved? I am using PC in Parallels starting today and cannot constrain lines, etc., using any of the keys.

[cadmonkey]

I ran into this problem last night and found the solution on the Parallels Site. Shift key fixed, but the zoomer works intermittently.

https://kb.parallels.com/123602

Good luck!