I had a disastrous crash due to an out of memory condition on the 2016 powerbook that I must keep to use PC9. When I fixed the problem I lost an entire section and elevation file. I found a recent copy on the new powerbook that I have (and on which I am beta testing PC10). I thought I could save it over to the old machine through dropbox, but it doesn't let me save down to PC9.
Is there a solution for this?
Saving down to PC9
Re: Saving down to PC9
Can't you open the file in PC10 and do a "save as" and select PC9 as the file type? I just ran a test and was able to do so, and was able to open the new file in PC9.
-
- Posts: 19
- Joined: Tue Sep 21, 2021 9:57 pm
Re: Saving down to PC9
1. There is no "Save As". I can Save, with the three dots, which basically turns it into a Save As, but the dropdown option for file version only shows powerCADD 10. There is no PowerCADD 9 option.
Re: Saving down to PC9
Save As... should be in the File menu immediately below Save...
If that is not appearing you might want to try deleting PowerCADD 10 and re-installing the latest beta from the link sent to you by AutoDesSys.
If that is not appearing you might want to try deleting PowerCADD 10 and re-installing the latest beta from the link sent to you by AutoDesSys.
- Attachments
-
- Screen Shot 2024-10-06 at 2.38.43 pm.png (55.72 KiB) Viewed 81 times